自然科学版 英文版
自然科学版 英文版
自然科学版 英文版
自然科学版 英文版
英文版编委
自然科学版 英文版
英文版首届青年编委

您目前所在的位置:首页 - 期刊简介 - 详细页面

中南大学学报(英文版)

Journal of Central South University

Vol. 28    No. 4    April 2021

[PDF Download]    [Flash Online]

    

Constitutive model and numerical simulation for injection molding of MgTiO3 ceramic parts
GU Xing-jian(顾星建)1, LIU Kai(刘凯)1, 2, HU Jia-ming(胡佳明)1, DU Yan-ying(杜艳迎)3, SUN Hua-jun(孙华君)1, 2

1. School of Materials Science and Engineering, Wuhan University of Technology, Wuhan 430070, China;
2. State Key Laboratory of Silicate Materials for Architectures, Wuhan University of Technology,
Wuhan 430070, China;
3. School of Logistics Engineering, Wuhan University of Technology, Wuhan 430070, China

Abstract:In order to predict the powder flow law of the injection molding process of MgTiO3 ceramic parts with complex structures, a constitutive model and numerical simulation method for MgTiO3 ceramic injection molding were established based on the Hunt method. The material parameters of MgTiO3 such as elastic modulus, Poisson ratio, glass transition temperature, thermal conductivity and specific heat capacity were measured. Based on the fitting curve and the material parameters measured, the cross-WLF viscosity model and P-V-T model required for MgTiO3 ceramic injection molding were optimized. Furthermore, the influence of process parameters on mold filling flow and distribution of parts defects was researched. It was found that the gate position, injection speed and melt temperature have greater influence on mold filling flow and the packing process has an obvious effect on parts’ defects. On this basis, the MgTiO3 ceramic parts injection molding experiment verification was carried out. By comparing the experimental results with the simulated results, it is found that the deformation error is within 1.5% and the density error is within 1%. Therefore, this research provided theoretical guidance for the engineering application of MgTiO3 ceramic parts fabricated by injection molding.

 

Key words: MgTiO3; ceramic injection molding; constitutive model; process parameters

中南大学学报(自然科学版)
  ISSN 1672-7207
CN 43-1426/N
ZDXZAC
中南大学学报(英文版)
  ISSN 2095-2899
CN 43-1516/TB
JCSTFT
版权所有:《中南大学学报(自然科学版、英文版)》编辑部
地 址:湖南省长沙市中南大学 邮编: 410083
电 话: 0731-88879765(中) 88836963(英) 传真: 0731-88877727
电子邮箱:zngdxb@csu.edu.cn 湘ICP备09001153号